ADJ DAT600 Data Distro 6

The Data Distro 6 is a dedicated 6-way DMX splitter and optical isolator designed to boost, branch, and isolate DMX data signals. It takes a incoming DMX signal and splits it across six independent output channels to prevent signal degradation and data corruption over long cable runs.

The unit features both 3-pin and 5-pin XLR connectors for its main DMX input and thru ports, as well as 3-pin and 5-pin XLR connectors on all six output channels. This dual-connector design allows for seamless integration with both 3-pin and 5-pin lighting gear without needing extra adapters.

Each output channel is optically isolated up to 1,000 Volts between input, outputs, and electric ground lines. This prevents electrical surges, ground loops, or static interference from traveling down the data line and damaging connected lighting fixtures or expensive DMX consoles.

Yes, the unit features removable 19-inch rack ears for standard 1U rack enclosure mounting. It also includes an M10 threaded bolt hole on the rear chassis for attaching a truss clamp, allowing it to be mounted overhead directly near your lighting rig.

Yes, it includes a dedicated DMX signal termination switch on the front panel with an indicator LED. Engaging the switch terminates the main DMX loop directly on the unit to eliminate data reflections and signal noise.

The front panel features individual status LED indicators for power, DMX signal input, signal fault warnings, and active transmission on all six output lines. This allows lighting techs to quickly diagnose cable faults or missing data lines at a glance.

Yes, the main input channel includes a dedicated DMX Thru output port (offered in both 3-pin and 5-pin XLR). This allows you to daisy-chain the incoming DMX signal to additional Data Distro 6 units or other control hardware without consuming any of the six primary output ports.