JBL EONONECOMPACT-5V9V - AKG DMS100/3

This specialized adapter cable converts the 5V DC power output from a USB port into a regulated 9V DC output to power external equipment. It is specifically designed to allow the JBL EON ONE Compact portable PA speaker to power an AKG DMS100 or DMS300 wireless microphone receiver directly from the speaker’s USB charging port.

The cable features a standard USB-A male connector on one end (plugs into the speaker or USB power source) and a 5.5mm / 2.1mm DC barrel connector on the other end (plugs into the wireless receiver's power jack).

No, while designed to complement the JBL EON ONE Compact’s built-in USB power ports, it can be used with any high-output 5V USB power source (such as power banks or USB wall adapters) that provides sufficient current to step up to 9V DC.

It is engineered for optimal performance with AKG DMS100 and DMS300 digital wireless receivers. It can also power other small 9V DC audio equipment that uses a center-positive 5.5mm x 2.1mm barrel jack and draws within the maximum supported current limit.

The DC barrel plug uses a standard center-positive configuration. Always verify that any non-AKG device connected to this cable shares the same center-positive polarity requirement to avoid electrical damage.

It eliminates the need for a separate AC wall outlet or extra power strip to run your wireless mic system. By drawing power directly from the speaker’s internal battery, it enables a 100% wireless, truly portable performance setup anywhere.

The cable measures approximately 3 feet (1 meter) in length, providing enough reach to connect a wireless receiver sitting on top of or near the PA speaker without excess cable clutter.

This is a power adapter cable only and does not carry audio signals. You will still need a standard 1/4-inch or XLR audio cable to connect the audio output of your wireless receiver into the mixer input of your speaker.